Blocks IPWatchdog

This page is beign temporarily revised with the newest updates.

Description:

The IPWatchdog blocks are used to verify the availability of a remote IP address based on an ARP or ICMP query.

Back to Libraries

IPWDG_ARP

Returns ARP ping status of given ip address

Asynchronous interface
in	IP_ADDR	string		ip address
in	TMO_S	int		timeout in seconds
out	Q	bool		status

IPWDG_ICMP

Returns ICMP ping status of given ip address

Asynchronous interface
in	IP_ADDR	string		ip address
in	TMO_S	int		timeout in seconds
out	Q	bool		status

Block behavior:

The pulse on EXEC triggers the IPWDG block. In the beginning ICMP/ARP request is send to the IP address. At the same time BUSY output changing the status of the log. 0 to 1, TMO_S running and block is waiting for response.

1. If a response is received during TMO_S, TMO_S is reseted. BUSY is set to log. 0, VALID is set to 1 (operation successful, output set) and Q is set to log. 1 (IP is available).

2. If a response is not received, BUSY remains in the log. 1 until TMO_S expires. After TMO_S expires BUSY goes to log.0, VALID goes to log.1 (operation successful, output set). Q remains in log. 0 (IP is not available).

Note: EXEC should be set to a value greater than TMO_S to avoid unnecessary restart when the block cycle is not completed and waits for TMO_S.

Examples

GEN_PULSE generates pulse every T#2s (2 seconds) to trigger IPWDG block. Within one cycle block waits to answer from the remote device (IP_ADDR) for TMO_S timer. If the remote device does not respond by this time, the output is set to log. 0. Otherwise, the output is set to log. 1.

IPWDG_ICMP

IPWDG_ARP

Back to Libraries